How about selecting tin through a spiral chute

How about selecting tin through a spiral chute

How to select tin for spiral chutes? 1. Explanation. Gravity beneficiation is widely used in the beneficiation of metal and non-ferrous metals due to its small environmental pollution and low cost. Fiberglass reinforced plastic chute is one of the gravity separation equipment, with a structural characteristic that the cross-section is in a cubic parabolic state, suitable for handling finer particle sizes of -0.2MM. During the sorting process, no flushing water is required, and the fine, medium, and tailings are segmented at the tail of the chute., How to select tin through a spiral chute? Secondly, the mineral mortar with the same technical principle is slowly fed to the surface of the spiral groove through the feeding groove installed at the end of the rotating groove head, and then operated for selection. The bottom of the rotating groove is equipped with a valve block type equipment selection groove, which divides the sorted products into three categories according to grade along the radial direction. By adjusting the position of the valve block to change the acquisition width of each device, the product gathering hopper allows the intercepted variable mineral flow to be converged and exported separately. The transverse plane of the fiberglass spiral chute is particularly suitable for the separation of fine ore materials when the slope of the curve changes. How to select tin with a spiral chute? 3. Advantages or characteristics: 1. Extremely high efficiency, high recycling rate, and precise screening of ore; 2. No power required; 3. Small weight, anti rust, durable and anti wear, durable and anti corrosion; 4. Low cost and long service life; 5. It has strong adaptability to fluctuation of feed volume, density, Granularity and grade. The friction force on the surface of 6 diamond sand makes the beneficiation efficiency better than other plastic surfaces. How to select tin by spiral chute. (2) Sand ore chute, processing 2-3mm Granularity ores. Spiral chute operation, how to select tin with spiral chute (3) Slurry spiral chute, feeding particle size<0.074mm., 5、 This machine is suitable for separating iron ore, Ilmenite, chromite, pyrite, zircon sand, Rutile, monazite, phosphate ore, tungsten ore, tin, tantalum ore, niobium ore and other non-ferrous metals, rare mineral metals or non-ferrous metal minerals with different density and specific gravity from small Granularity of 0.3-0.02MM. How about selecting tin through spiral chutes How about selecting tin through spiral chutes

How about selecting tin through a spiral chute