Spiral chute titanium ore selection

Spiral chute titanium ore selection

Spiral chute selection of titanium ore Spiral chute m-type selection of graphite. 1、 Overview: Chute sorting belongs to the step of slope flow sorting. Mineral mortar is fed to a partially inclined chute or inclined surface. With the assistance of flowing water, the mineral particle group is not tightly fastened and layered. The lighter mineral material on the upper part is quickly discharged out of the groove, while the heavy mineral material on the lower part is stagnant inside the groove or flows out at a low speed from the lower end. After being connected, the selected ore or tailings are obtained. The spiral concentrator is a mechanical device for mining and beneficiation, making it ideal for sand mining in coastal, river, sand beach, and stream beds. The product has the characteristics of appropriate structure, easy installation, small land occupation, easy operation, stable beneficiation, clear mineral separation, high yield, high-efficiency beneficiation, ultra-high enrichment ratio, high recycling rate, and reliable operation. It has the advantages of light weight, moisture prevention, rust prevention, corrosion resistance, and strong applicability to fluctuations in feed volume and density, Granularity, and grade. 2、 Operating principle. Equal mineral mortar is slowly fed onto the surface of the rotating groove by installing the feeding chute at the end of the spiral groove head, and selection is carried out. The tail of the spiral groove is equipped with a valve block type equipment to select the groove, and the sorted products are divided into three types according to grade along the radial direction. By adjusting the position of the valve block to change the cutting width of each equipment, the product gathering hopper allows the obtained multi head ore flow to be collected and exported separately. The cross section and slope of the curve of the fiberglass chute are very suitable for the sorting of fine particle materials. Spiral chute titanium ore selection III. Characteristics. This machine is suitable for separating fine materials with Granularity of 0.3-0.02MM to obtain iron ore, Ilmenite, ferrochrome, ferrosulfide, zircon ore, Rutile ore, monazite ore, phosphate ore, tungsten ore, tin ore, tantalum niobium ore, tantalum niobium ore or other nonferrous metals, rare mineral metals and nonferrous metal mineral bodies with density and specific gravity differences. This machine also has the advantages of stable sorting process, simple control, wide range of allowable changes in ore concentration, high enrichment ratio, high recovery probability, small area occupation, low water consumption, simple structure, no power required, strong processing capacity, simple installation, simple operation, low investment, and quick effectiveness. The spiral chute selects titanium ore IV. According to the particle size of processed ore materials, the chute can be divided into three types: (1) coarse chute, the maximum Granularity of ore feeding is more than 2-3 mm, and the maximum can reach 100-200 mm. (2) Sand ore chute, processing 2-3mm Granularity ores. Research on the parameters of spiral chutes. (3) Slurry spiral chute, feeding particle size ＜ 0.074 mm. 5、 The use of spiral chutes in the field is suitable for processing 0.6-0.03 millimeters or vein ore and this sand ore, but it is unfavorable for sorting when the mud content is high. Currently, it has been widely used for processing iron ore, tungsten, tin placer, tantalum niobium ore, bay and riverbank placer or placer gold, and so on. Spiral chute titanium ore selection Spiral chute titanium ore selection

Spiral chute titanium ore selection