Debugging of spiral chutes

Debugging of Spiral Chutes 1. Introduction: Chute sorting is under the process of slope flow sorting. Mineral mortar is fed to a partially inclined chute or inclined surface, and with the assistance of water, the mineral particle group becomes loose and layered. The upper layer of light minerals quickly exits the outside of the chute, while the lower layer of heavy minerals stays inside the chute or flows out at low speed from the bottom. After differentiation, the selected ore or tailings are obtained. Spiral chutes are machinery for mining and mineral processing, making them particularly ideal for mining sand deposits in bays, rivers, sandbanks, and streams. The equipment has the characteristics of correct structure, simple installation, small footprint, easy operation, stable beneficiation, clear mineral separation, large processing capacity, high efficiency beneficiation and enrichment ratio, high recovery and utilization rate, and reliable operation. It has the advantages of small weight, moisture prevention, rust prevention, corrosion resistance, and strong adaptability to the fluctuation of feed volume, density, Granularity, and grade. 2、 The uniform mortar is slowly fed onto the rotating groove surface through the feeding chute installed at the head of the spiral groove for selection. The tail of the spiral groove is equipped with a valve type product acquisition groove, which divides the sorting equipment into three categories according to grade along the radial direction. By adjusting the orientation of the valve block to change the cutting width of each equipment, the product gathering hopper enables the selected multi head ore flow to be densely led out. The transverse section of the fiberglass chute has a change in the slope of the curve, which is particularly suitable for the selection of fine-grained materials. Adjustment of spiral chute III. Characteristics This machine is suitable for separating iron ore, ilmenite ore, chromite ore, pyrite, zircon sand, Rutile, monazite, phosgenite, tungsten sand, sand tin, tantalite, tantalite and niobium ore from other nonferrous metals, rare mineral metals and this nonferrous metal mineral body with gravity difference. This product also has the advantages of stable sorting process, simple control, wide range of allowable changes in ore concentration, high enrichment ratio, high recycling rate, small land area, small water consumption, simple structure, no power, large production capacity, easy installation, simple operation, small investment, and quick effectiveness. Debugging of Spiral Chutes 4. The structure of spiral chutes consists of a feeding device, a cross (tripod), a feeding groove, a spiral groove, a receiving groove, a gathering bucket, and a groove pillar. 5、 Purpose This equipment is suitable for separating iron, ferrotitanium, ferrochrome, ferrosulfide, zircon, Rutile, monazite, phosphorus ethyl, tungsten sand, tin ore, tantalum, niobium ore and other non-ferrous metals, rare mineral metals and non-ferrous metal minerals with gravity difference from fine materials with Granularity of 0.3-0.02mm. Debugging of Spiral Chutes Debugging of Spiral Chutes