Iron ore spiral chute

Iron ore spiral chute 1. Introduction: Gravity beneficiation is widely used in the beneficiation of metallic and non-metallic ores due to its low pollution and low cost. Fiberglass reinforced plastic chute is one of the gravity separation equipment, with a structural feature that the cross-section presents a cubic parabolic state, suitable for processing finer particle sizes of -0.2MM. During the selection process, do not add water for flushing, and divide the chute into sections at the end to select fine, medium, and tailings. 2、 Working principle: The spiral ore separator does not need to be limited to stacking on the cross (or tripod) of the support table. The same mortar is slowly fed onto the spiral groove surface through the feeding chute installed at the beginning of the rotating groove, and selected for operation. The bottom is equipped with a valve block type equipment cutting groove, which divides the sorted products into three (or four) categories according to grade along the radial direction. Change the selection width of each equipment by adjusting the orientation of the valve block. The product gathering bucket is a concentric circular tube that enables the diverse mineral flows obtained to converge and export differently. The transverse plane of the fiberglass spiral chute and the slope of the curve change, making it particularly suitable for the selection of small particle materials. iron ore spiral chute III. Highlights and characteristics: 1. Ultra high efficiency, high recovery rate, and precise ore separation; 2. No power required; 3. Lightweight, rust resistant, wear-resistant, and corrosion-resistant; 4. Low operating cost and long service life; 5. Strong adaptability to fluctuations in ore feed volume, concentration, particle size, and grade; The friction force formed by the surface of 6 diamond sand makes the beneficiation effect superior to other plastic surfaces. Iron ore spiral chute IV. According to the size of ore processed, the chute can be divided into three categories: (1) coarse spiral chute. The maximum Granularity of ore feeding is more than 2-3MM, and the maximum can reach 100-200mm. (2) The sand ore chute is used to handle 2-3mm sized ore materials. (3) Slurry chute, feeding particle size less than 0.074 millimeters. 5、 In the application field, the glass fiber reinforced plastic chute is suitable for separating fine iron ore, ferrotitanium ore, chromite ore, pyrite ore, placer tin ore, tantalum niobium ore, placer gold ore, coal mine, monazite ore, Rutile ore, zircon ore and rare earth ore, and has enough density ratio difference to obtain other metals and non gold minerals. Iron ore spiral chute Iron ore spiral chute