Glass cylinder spiral chute

Glass cylinder spiral chute 1. Overview: The chute sorting belongs to the inclined flow sorting process. The mortar is fed to some inclined grooves or slopes, and with the assistance of water flow, the mineral particles become loose and layered. The upper layer of light minerals are quickly discharged outside the groove, while the lower layer of heavy minerals are retained inside the groove or slowly discharged from the lower part. After each is collected, the selected ore and tailings can be obtained. The fiberglass spiral chute is a mining and beneficiation machine, making it ideal for mining and beneficiation of mineral sand on beaches, river beds, sand banks, and streams. The product has the characteristics of correct structure, simple installation, small footprint, simple operation, stable beneficiation, clear mineral separation, high processing yield, high efficiency, high beneficiation enrichment ratio, high recovery rate, and reliable operation. It has the advantages of light weight, moisture prevention, rust prevention, durability and corrosion resistance, and strong adaptability to fluctuations in feed volume, density, Granularity and grade. 2、 By using a method, the spiral chute is erected and aligned with the vertical line. An iron frame or wood is used to position it in a suitable position. The sand and ore are pumped by a slurry pump to the two feeding ports above the spiral, where water is added and the density of the mineral slurry is adjusted. The slurry naturally swirls from high to low, generating an inertial centrifugal force in the swirling slope flow velocity. The difference is based on the specific gravity, particle size, and state of the mineral sand, By utilizing the gravity and centrifugal force of the swirling flow, the sand and ore are separated. The selected ore enters the concentrate hopper and is piped out. The tailings are discharged into the tailings hopper and moved to the sand tank through a pipeline, and then discharged by a mortar pump, completing the entire beneficiation process. Glass Cylinder Spiral Chute III. Advantages and Characteristics 1. High efficiency, high recovery rate, and accurate ore sorting; 2. No power required; 3. Lightweight, rust resistant, durable, wear-resistant, and corrosion-resistant; 4. Low operating costs and long service life; 5. Strong adaptability to fluctuation of feed volume, density, Granularity and grade; The friction caused by the appearance of 6 diamond sand makes the beneficiation efficiency better than other plastic surfaces. Glass cylinder spiral chute 4. Structural composition: The fiberglass chute is composed of 6 parts, including a feeding homogenizer, a feeding groove, a rotating groove, a product cutting groove, an equipment gathering hopper or groove bracket (including a cross or triangular frame), etc. The spiral groove connected by the spiral plate is the main component. The rotating plate is made of fiberglass (fiber reinforced coal gangue), which is connected together through screws. The selected surface of the rotating groove has a predetermined wear-resistant layer. It also has the advantages of lightweight, sturdy, and durable consumer goods. Above the spiral groove, there is a multi tube feeding homogenizer for ore dressing and averaging, with simple control. The mineral screening device is freely placed on a cross (or tripod) on a support table. The evenly distributed mortar is slowly fed to the rotating groove surface by installing it on the feeding groove at the end of the spiral groove head, and sorting is carried out. The tail end of the spiral groove is installed in a valve block type new product acquisition groove, and the selected new products are divided into three categories (or four categories) of new equipment along the radial direction according to grade. Change the selection width of each new product by adjusting the orientation of the valve block. The new product gathering bucket is a concentric circular tube that allows the intercepted variable mineral flows to be gathered and exported separately. The cross section and slope of the curve of the spiral concentrator are particularly suitable for the separation of fine ore materials. 5、 Application field: FRP chute is suitable for separating fine iron ore, Ilmenite, Chromite, pyrite, tin ore, tantalum niobium ore, placer gold, coal mine, monazite ore, Rutile ore, zircon ore, rare earth ore, and other metal and non-ferrous metal minerals with completely enough density ratio difference. Glass cylinder spiral chute Glass cylinder spiral chute