Equipment for influencing factors of spiral chutes

Equipment for influencing factors of spiral chutes

Equipment for influencing factors of spiral chutes: 1. Overview: Chute selection belongs to the step of slope flow selection. Mineral mortar is fed to a partially inclined chute or inclined surface. With the assistance of flowing water, the mineral particle group is not tightly fastened and layered. The lighter mineral material on the upper part is quickly discharged out of the groove, while the heavy mineral material on the lower part is stagnant inside the groove or flows out at a low speed from the lower end. After being connected, the selected ore or tailings are obtained. The spiral concentrator is a mechanical device for mining and beneficiation, making it ideal for sand mining in coastal, river, sand beach, and stream beds. The product has the characteristics of appropriate structure, easy installation, small land occupation, easy operation, stable beneficiation, clear mineral separation, high yield, high-efficiency beneficiation, ultra-high enrichment ratio, high recycling rate, and reliable operation. It has the advantages of light weight, moisture prevention, rust prevention, corrosion resistance, and strong applicability to fluctuations in feed volume and density, Granularity, and grade. 2、 The principle of operation is that the spiral concentrator does not limit the placement of the mineral screening device on the cross (or tripod) of the support table. The average mineral mortar is slowly fed onto the spiral groove surface through a feeding groove installed on the rotating groove head, and the selection is carried out. The bottom is equipped with a valve block type equipment cutting groove, allowing the sorted products to be divided into three (or four) types according to grade along the radial direction. Change the selection width of each device by adjusting the position of the valve block. The product gathering bucket is a concentric circular tube that aggregates and leads out the obtained multi head ore flow. The transverse section of the fiberglass chute and the change in slope of the curve are particularly suitable for the selection of small particle materials. The third factor affecting the equipment of the spiral chute is the characteristic spiral chute. Due to its low power consumption, simple structure, small area occupation, simple operation, stable beneficiation, clear screening of ore, no moving parts, easy maintenance and management, and large single area output, it is more concerned in many gravity beneficiation equipment. The machine has a wide and stable groove surface, and the area where mineral mortar exhibits laminar flow is quite large, making it more suitable for processing medium to fine (-4MM) sized ores. We in China have produced spiral concentrators with diameters of 400, 600, 900, and 1200 millimeters, Ф The processing capacity of 1200mm four heads is about 4-6 tons/hour. The influencing factors of the spiral chute are equipment . The structure of the spiral concentrator consists of a feeding homogenizer, a cross (tripod), a feeding chute, a spiral groove, a cutting groove, a gathering bucket, and a groove support. 5、 Scope of use: FRP spiral chute is suitable for separating fine grained iron, ferrotitanium, ferrochrome, pyrite, placer tin, tantalum niobium, gold, coal, monazite, Rutile, zircon, rare earth or other metal and non-metallic mineral materials with sufficient Density contrast. Equipment for influencing factors of spiral chutes Equipment for influencing factors of spiral chutes

Equipment for influencing factors of spiral chutes