Spiral chute m-type graphite selection

Spiral chute m-type graphite selection

Spiral chute m-type graphite selection: 1. Introduction: The chute beneficiation includes an inclined surface flow separation process. The slurry is fed to a partially inclined chute or inclined surface, and with the assistance of water flow, the mineral particle group becomes loose and layered. The light minerals on the upper part are quickly discharged to the outside of the chute, while the heavier minerals on the lower part stagnate in the inner chute or slowly discharge from the lower part. After obtaining each, concentrate and tailings can be obtained. Glass fiber reinforced plastic chutes are equipment for mining and beneficiation, making them ideal for sand mining by the sea, riverbanks, sandbanks, and streams. The product has the characteristics of correct structure, simple installation, small footprint, easy operation, stable beneficiation, clear screening of minerals, high processing yield, high efficiency, high beneficiation enrichment ratio, high recycling rate, and stable operation. It has the advantages of light weight, moisture-proof, rust prevention, corrosion prevention, strong adaptability to the fluctuation of feed volume and density, Granularity, and grade. 2、 Technical principle: The fiberglass spiral chute mineral separator is not limited to stacking on the cross (or tripod) of the support table. The average mineral mortar is slowly fed onto the spiral groove surface through a feeding groove installed at the end of the rotating groove head for sorting. The tail is equipped with a valve type product selection slot, which divides the selection equipment into three types (or four types) according to grade along the radial direction. Change the cutting width of each product by adjusting the orientation of the valve block. The equipment gathering bucket is a concentric circular tube that allows the obtained multi head ore flow to gather and lead out. The cross section of the spiral chute is particularly suitable for the selection of fine ore particles due to changes in the slope of the curve. spiral chute m-type graphite separation III, characteristic FRP chute is particularly concerned in various gravity separation equipment due to its low power consumption, simple structure, less land occupation, simple operation, stable beneficiation, clear beneficiation, no need for moving accessories, convenient Computerized maintenance management system, large production per unit size and other characteristics. The machinery has a wide or relatively flat groove surface, and the mortar presents a large laminar flow area, which is more suitable for processing medium to fine (-4MM) particle size ores. We in China have made spiral concentrators with diameters of 400, 600, 900, and 1200mm, Ф The production capacity of 1200mm four heads is about 4-6 tons/hour. The spiral chute m type selects graphite . 4. According to the Granularity of the processed ore, the chute can be divided into three categories: (1) coarse size chute. The maximum Granularity of the feed is more than 2-3 mm, and the maximum can reach 100-200 mm. (2) The ore chute is used to handle 2-3mm sized ore materials. (3) Slurry chute, with a feeding particle size less than 0.074MM. 5、 Applicable field: FRP chutes are suitable for separating fine iron ore, ferrotitanium ore, chromite ore, pyrite ore, tin ore, tantalum niobium ore, placer gold ore, coal, monazite ore, Rutile ore, zircon ore, rare earth and other metal and non nonferrous metal minerals with complete density ratio difference. Spiral chute m-type graphite selection Spiral chute m-type graphite selection

Spiral chute m-type graphite selection