Rubber spiral chute

Rubber spiral chute 1. Description. The chute sorting includes the inclined surface flow sorting process. Mortar is fed to some inclined grooves or slopes. Under the push of water flow, the mineral particle group becomes loose and layered. The upper layer of light mineral material is quickly discharged from the outside of the groove, while the lower layer of heavy mineral is retained inside the groove or slowly discharged from the bottom. After each is taken, the selected ore and tailings can be obtained. The fiberglass chute is a mining and beneficiation machine, especially ideal for sand mining and beneficiation on beaches, rivers, sand banks, and streams. The equipment has the characteristics of appropriate structure, simple installation, small footprint, easy operation, stable beneficiation, clear screening of minerals, large production capacity, high efficiency, high beneficiation enrichment ratio, high recycling rate, and stable operation. And it has advantages such as light weight, moisture prevention, rust prevention, strong corrosion resistance, and strong adaptability to fluctuations in ore feed volume, concentration, particle size, and grade. 2、 Usage method. Set up the fiberglass chute, align it with the vertical line, use an iron frame or wood to stabilize it in a suitable position, and use a sand pump to deliver the mineral sand to the two feeding ports on the spiral top. Add water to adjust the concentration of the mineral slurry, and the mineral mortar will naturally swirl from top to bottom. In the rotating slope flow rate, a single inertial centrifugal force will be generated. Based on the differences in the specific gravity, particle size, and state of the sand, the gravity and centrifugal force will be obtained through the swirl, Separating the sand and ore, the concentrate flows into the beneficiation hopper and is piped out. The tailings are discharged into the tailings hopper and moved to the sand pit through a pipeline, and then discharged by a sand pump, completing the entire beneficiation process. Rubber Spiral Chute III. Advantages and Characteristics: 1. Stable, easy to control, with a relatively large concentration range. 2. The material has strong production and processing capabilities, high enrichment ratio, and high recycling probability. 3. Small footprint, low water consumption, simple construction, and no need for power. 4. Easy to install, easy to operate, minimal investment, and fast recovery of benefits. Rubber spiral chute . Rubber spiral chute 4. The structure of the fiberglass spiral chute consists of six parts: a feeding homogenizer, a feeding chute, a rotating groove, an equipment acquisition groove, a product gathering hopper, and a groove bracket (including a cross or triangular frame). The spiral groove formed by connecting the rotating blades is a key component. The spiral plate is made of fiberglass (fiberglass reinforced coal gangue) and connected together by bolts. The sorting surface of the rotating groove has a pre made durable and wear-resistant layer. He also has the advantages of lightweight, sturdy, and long-lasting durability in consumer goods. The head of the spiral groove is equipped with a multi tube feeding homogenizer for ore dressing, which is also easy to operate. The ore separator is freely placed on the cross (or tripod) on the support table. The evenly distributed mortar is slowly fed onto the surface of the spiral groove through the feeding groove installed at the beginning of the rotating groove, and the selection is carried out. The bottom of the rotating groove is installed in a valve block type new product cutting groove, and the sorted new products are divided into three categories (or four types) of new equipment along the radial direction according to grade. Change the selection width of each new product by adjusting the position of the valve block. The new product gathering bucket is a concentric circular tube that allows the obtained multi head ore flow to be gathered and exported separately. The transverse plane of the spiral chute and the different slopes of the curves are very suitable for the selection of small particle mineral materials. 5、 Scope of utilization. Spiral concentrators are suitable for processing 0.6-0.03mm or vein ores and minerals, but high mud content is unfavorable for separation. Nowadays, it is widely used for processing iron ore, tungsten, tin, tantalum niobium ore, bay or riverbank ore sand, and gold ore. Rubber spiral chute Rubber spiral chute