Glass cylinder spiral chute

Glass cylinder spiral chute 1. Product introduction. A gravity beneficiation equipment that utilizes the inertial centrifugal force that occurs during the spiral rotation movement of mineral pulp to separate light and heavy mineral materials. 2、 Apply techniques. Let the spiral concentrator stand up, align it with the vertical line, use an iron shelf or wood to stabilize it in a suitable position, and use the sand pump to transport the ore sand to the two feeding ports on the spiral head. Add make-up water to adjust the concentration of the ore slurry. The mineral slurry naturally swirls from high to low, and an inertial centrifugal force occurs in the flow rate of the swirling inclined plane. The gravity or centrifugal force is obtained through the swirling flow based on the difference in the gravity, Granularity and shape of the placer, The ore sand is separated, and the concentrate is discharged into the selected ore hopper and connected out through pipelines. The tailings flow into the tailings hopper and are connected to the sand ore pool through pipelines, and then discharged by a mortar pump, completing the entire beneficiation process. Glass cylinder spiral chute III. Advantages or characteristics. 1. High efficiency, high recycling rate, and correct mineral sorting; 2. No power required; 3. Lightweight, rust resistant, durable, wear resistant, and corrosion-resistant; 4. Low cost and long service life; 5. It is applicable to the fluctuation of feed volume, density, Granularity and grade; The friction force on the surface of 6 diamond sand makes the beneficiation efficiency better than other plastic surfaces. What is the recovery rate of tin ore in the glass cylinder spiral chute? The glass cylinder spiral chute is composed of six parts: a feeding homogenizer, a feeding chute, a spiral groove, an equipment cutting groove, a product gathering hopper, and a bracket (including a cross or triangular frame). The rotating groove connected by spiral blades is a key component. The rotating plate is made of fiberglass (fiber reinforced coal gangue) and connected together by bolts. The spiral groove has a pre made wear-resistant layer on the selected surface. He also has the advantage of lightweight, sturdy, and long-lasting consumables. The rotary groove is equipped with a multi tube ore feeding homogenizer to screen minerals, which is easy to control. The mineral separator does not need to be placed on a cross (or tripod) on a support table. The mineral mortar with an average score is slowly fed onto the surface of the rotating groove through a feeding chute installed at the head of the spiral groove for sorting. The bottom of the spiral groove is installed in a valve block type new product cutting groove, and the selected new equipment will be divided into three (or four) types of new products along the radial direction according to grade. Change the selection width of each new product by adjusting the orientation of the valve block. The new equipment gathering bucket is a concentric circular tube that allows the obtained multi-directional mineral flow to be differentiated, gathered, and led out. The transverse plane of the spiral chute and the slope change of the curve are extremely suitable for the sorting of fine-grained materials. 5、 The spiral concentrator is suitable for separating fine grained iron ore, Ilmenite, Chromite, pyrite, cassiterite, tantalum niobium ore, placer gold ore, coal, monazite ore, Rutile ore, zircon sand, rare earth ore and other metal and non-metallic mineral materials with sufficient density ratio difference. Glass cylinder spiral chute Glass cylinder spiral chute