Spiral chute process flow

Spiral chute process flow. 1、 Overview: Gravity beneficiation is widely used in the beneficiation of metallic and non-metallic minerals due to its small environmental pollution and low cost. Fiberglass reinforced plastic chute is a type of gravity sorting machine, with a structural characteristic that the cross-section presents a cubic parabolic state, suitable for handling finer particle levels of -0.2MM. In the sorting step, there is no need to add water for flushing, and the fine, medium, and tailings are segmented at the tail end of the chute. What does the L of the spiral chute represent? Secondly, the working principle of the fiberglass chute separator is freely placed on the cross (or tripod) of the support table. Equal mortar is slowly fed onto the surface of the rotating groove through the feeding chute installed at the end of the spiral groove head, and sorting is carried out. The tail end is equipped with a valve block type product acquisition tank, which divides the selected equipment into three types (or four types) according to grade along the radial direction. Change the cutting width of each product by adjusting the orientation of the valve block. The equipment gathering bucket is a concentric circular tube that allows the selected variable ore flows to converge and export separately. The transverse plane of the fiberglass spiral chute has different slopes, which is very suitable for the separation of fine ore particles. Spiral Chute Process Flow III. Highlights and Characteristics. 1. Stable, easy to control, with a relatively large concentration range. 2. The material production and processing capacity is large, with a high enrichment ratio and a high probability of recovery. 3. The area is not occupied much, consumes less water, has a simple structure, and does not require power. 4. Easy installation, simple operation, low investment, and quick returns. Spiral chute process flow IV. Categories. According to the particle size of the processed ore material, the chutes can be divided into three types: (1) coarse grain chutes, with a maximum particle size of 2-3mm or more for ore feeding, and a maximum of 100-200mm. (2) The ore sand chute is used to handle 2-3mm sized ore materials. (3) Slurry chute, feeding Granularity is less than 0.074MM. 5、 Use This machine is suitable for separating small materials with a particle size of 0.3-0.02mm to obtain iron ore, ilmenite, Chromite, pyrite, zircon, Rutile ore, monazite ore, phosphorus, tungsten ore, tin ore, tantalum niobium ore, tantalum niobium ore and other non-ferrous metal ores, rare mineral metals and non-metallic mineral bodies with gravity differences. Spiral chute process flow Spiral chute process flow