Density requirements for spiral chutes

Density requirements for spiral chutes

The requirement of density for spiral chutes is that gravity beneficiation is widely used in the beneficiation of metal and non-ferrous metals due to its small environmental pollution and low cost. Fiberglass reinforced plastic chute is one of the gravity separation equipment, with a structural characteristic that the cross-section is in a cubic parabolic state, suitable for handling finer particle sizes of -0.2MM. During the sorting process, no flushing water is required, and the fine, medium, and tailings are segmented at the tail of the chute. 2、 Production principle: The spiral chute screening machine is freely placed on the cross (or tripod) on the support table. The uniform mortar is slowly fed to the surface of the rotating groove through the feeding groove installed at the beginning of the spiral groove, and the selection is carried out. The tail end is equipped with a valve block type equipment cutting groove, allowing the sorted products to be divided into three types (or four types) according to grade along the radial direction. Change the selection width of each equipment by adjusting the orientation of the valve block. The product gathering bucket is a concentric circular tube that converges and induces the obtained multi head ore flow. The cross-section of the fiberglass spiral chute and the slope of the curve change, which is very suitable for the separation of fine mineral materials. The requirements for density of the spiral chute are three. Advantages and characteristics: 1. Stable, easy to operate, and a large density range. 2. The production and processing of materials have a large production capacity, high enrichment ratio, and high recovery rate. 3. Small space occupation, low water consumption, simple structure, and no need for power. 4. Installation is simple and easy to operate, with low investment and fast returns. The density requirements for spiral chutes are . 4. The structural composition of a fiberglass spiral chute is composed of six parts: a feeding homogenizer, a feeding chute, a spiral groove, a product selection groove, an equipment gathering hopper, and a groove bracket (including a cross or triangular frame). The rotating groove connected by spiral blades is a key accessory. The rotating plate is made of fiberglass (fiberglass reinforced coal gangue) and connected together by screws. The spiral groove has a pre made durable wear-resistant layer on the selected surface. He also has the advantage of lightweight, sturdy, and long-lasting consumables. The rotating groove is equipped with a multi tube feeding homogenizer to evenly distribute the ore, and the operation is not complicated. The screening machine is freely stacked on a cross (or tripod) on a support table. The evenly distributed mortar is slowly fed onto the surface of the spiral groove through the feeding chute installed at the beginning of the spiral groove, and sorting is carried out. The bottom of the rotating groove is installed in a valve block type new product cutting groove, and the selected new equipment is divided into three types (or four categories) of new products along the radial direction according to grade. Change the width of each new product by adjusting the position of the valve block. The new equipment gathering bucket is a concentric circular tube that allows the selected multi head ore flow to converge and export separately. The cross-section of the spiral chute and the slope of the curve change greatly in the separation of fine particle materials. 5、 Scope of application: FRP spiral chute is used to separate fine grained iron ore, ilmenite ore, chromite ore, pyrite ore, sand tin, tantalum niobium ore, placer gold ore, coal mine, monazite, Rutile, zircon ore, rare earth ore or other metal and non-metallic mineral materials with sufficient Density contrast. Requirements for Density of Spiral Chutes Requirements for Density of Spiral Chutes

Density requirements for spiral chutes