A Study on the Parameters of Spiral Chutes

A Study on the Parameters of Spiral Chutes

Research on the parameters of spiral chutes: 1. Gravity beneficiation is widely used in the beneficiation of metal and non-ferrous metals due to its small environmental pollution and low cost. Fiberglass reinforced plastic chute is one of the gravity separation equipment, with a structural characteristic that the cross-section is in a cubic parabolic state, suitable for handling finer particle sizes of -0.2MM. During the sorting process, no flushing water is required, and the fine, medium, and tailings are segmented at the tail of the chute. 2、 The production principle is that the slurry is evenly distributed and slowly fed onto the surface of the spiral groove through the feeding chute installed on the rotating groove head, implementing sorting. The bottom of the rotating groove is equipped with a valve block type product selection groove, which divides the selection equipment into three types according to grade along the radial direction. By adjusting the position of the valve block to change the cutting width of each product, the equipment gathering hopper allows for the differentiation and aggregation of the obtained variable mineral flow. The cross-section of the spiral chute and the slope change of the curve are very suitable for the selection of fine particle materials. Research on the Parameters of the Spiral Chute III. Advantages and Characteristics: 1. High efficiency, high recovery probability, and precise mineral sorting; 2. No power required; 3. Lightweight, rust resistant, durable, wear-resistant, and highly corrosion-resistant; 4. Low operating costs and long service life; 5. Strong adaptability to fluctuation of feed volume, density, Granularity and grade; The frictional force on the surface of 6 diamond sand makes the beneficiation efficiency superior to other plastic surfaces. Research on the Parameters of Spiral Chutes 4. Structural Composition: Spiral chutes are composed of six parts: feeding homogenizers, feeding chutes, rotating chutes, product cutting chutes, equipment gathering buckets, and slot brackets (including crosses or triangular brackets). The spiral groove connected by the rotating plate is a key accessory. The spiral plate is made of fiberglass (fiberglass reinforced coal gangue) and connected together through screws. The sorting surface of the rotating groove has one layer of pre designed durable wear-resistant layer. It has the advantages of lightweight, sturdy, and durable consumer goods. The spiral groove is equipped with a multi tube feeding homogenizer to screen minerals evenly, which is not cumbersome to operate. The mineral sorting equipment is freely stacked on the cross (or tripod) of the support table. The evenly distributed mortar is slowly fed to the spiral groove surface through the feeding groove installed at the head of the rotating groove, and the selection is carried out. The bottom of the rotating groove is installed in a valve block type new equipment to obtain the groove, allowing the sorted new products to be divided into three (or four) new products according to grade along the radial direction. Change the selection width of each new device by adjusting the position of the valve block. The new product gathering bucket is a concentric circular tube that distinguishes and converges the intercepted multi head ore flow. The cross-section of the fiberglass chute and the change in slope of the curve are particularly applicable for the selection of fine-grained materials. 5、 Application This product is applicable to sorting iron, ferrotitanium, ferrochrome, ferrosulfide, zircon, Rutile, monazite, phosphate rock, wolframite, cassiterite, tantalum ore, niobium ore and other non-ferrous metal ores, rare mineral metals and non-metallic minerals with specific gravity difference. Research on the Parameters of Spiral Chutes

A Study on the Parameters of Spiral Chutes