How to feed ore with spiral chutes

How to feed ore with spiral chutes

How to use spiral chutes to select tailings for mining spiral chutes and jigs? Firstly, it is explained that the spiral concentrator combines the characteristics of spiral chutes, gravity spiral chutes, shakers, and centrifugal gravity concentrators. After relevant scientific research organized by the Ministry of Metallurgical Industry, design, universities, and this beneficiation company and other departments have conducted appraisal and passed the appraisal, it is recognized that this type of machine has excellent performance, advanced sorting objectives, and has won the Science and Technology Research Achievement Award from the Ministry of Metallurgical Industry, It has been widely used in nonferrous and Ferrous mines. This equipment is applicable to sorting iron ore, Ilmenite, Chromite, pyrite, zircon, Rutile, monazite, phengite, tungsten ore, tin, tantalite, niobium and other nonferrous metal, rare metal and nonferrous metal ore bodies with different density and specific gravity. 2、 Production principles. How to freely place the spiral chute screening device on the cross (or tripod) on the support table. The uniform mortar is slowly fed to the surface of the rotating groove through the feeding groove installed at the beginning of the spiral groove, and the selection is carried out. The tail end is equipped with a valve block type equipment cutting groove, allowing the sorted products to be divided into three types (or four types) according to grade along the radial direction. Change the selection width of each equipment by adjusting the orientation of the valve block. The product gathering bucket is a concentric circular tube that converges and induces the obtained multi head ore flow. The cross-section of the fiberglass spiral chute and the slope of the curve change, which is very suitable for the separation of fine mineral materials. How to provide ore with the advantages and characteristics of the spiral chute. 1. Extremely high efficiency, high recycling rate, and precise screening of ore; 2. No power required; 3. Lightweight, rust resistant, wear-resistant, and corrosion-resistant; 4. Low cost and long application life; 5. Strong adaptability to fluctuation of ore feeding amount, concentration, Granularity and grade; The frictional force formed on the surface of 6 diamond sand makes the beneficiation efficiency better than other plastic surfaces. How to Construct a Spiral Chute for Mining IV. The spiral chute is composed of six parts: a feeding homogenizer, a feeding chute, a rotating chute, a product intercepting chute, an equipment gathering hopper, and a bracket for this chute (including a cross or tripod). The spiral groove connected by the rotating plate is a key accessory. The spiral plate is made of fiberglass (fiberglass reinforced with coal gangue) and connected together by bolts. The sorting surface of the rotating groove has a pre made wear-resistant layer. It has the advantages of lightweight, sturdy, and long-lasting consumer goods that are not easily damaged. The spiral groove is equipped with a multi tube feeding homogenizer for ore dressing, which is easy to operate. There is no need to restrict the stacking of mineral sievers on the cross (or tripod) of the support table. The evenly distributed mineral mortar is slowly fed to the surface of the spiral groove through the feeding groove at the beginning of the rotating groove, and then selected for operation. The bottom of the rotating groove is equipped with a valve block type new product selection groove, which allows the sorting equipment to be divided into three categories (or four types) of new products according to grade along the radial direction. Change the acquisition width of each new product by adjusting the position of the valve block. The new product gathering bucket is a concentric circular tube that collects and exports the intercepted variable mineral flows. The cross section and slope of the curve of the fiberglass chute are very suitable for the selection of fine particle materials. 5、 Application field: Spiral chutes are used for processing 0.6-0.03mm or vein ores and minerals, but high mud content is unfavorable for sorting. It has now been widely used for processing iron, tungsten, sand tin, tantalum niobium mines, beach or river sand mines, and sand gold, among others. How to feed ore with spiral chutes How to feed ore with spiral chutes

How to feed ore with spiral chutes